How to Build a Chaise Lounge
Rest in a chair may be appropriate platform for a meal, but to completely relax and enjoy your deck, you can build a chaise lounge for your comfort. It can be difficult to build than a conventional chair, because some moving parts, but the reward makes it all worth it.
Materials in the design of a chaise lounge NEEDED
Some of the materials needed to achieve this is to project the stock of your choice (two out of four, one after 'three or one to 2), an anchor, nails, screws and carpenter's glue. The tools you need for this venture, drill a series, 4-5 in three pictures, hammer, saw, paper and pencil, tape measure and a router.
STEPS IN THE LOUNGE build your
There are numerous examples of deck chairs. If you want to build a basic room, selecting the type of wood you start. Teak is a good choice when your position is constantly exposed to the elements. Rooms have a large amountpieces that are connected with them. Carefully cut each part individually and then grinding them with enamel paint them before you make everything easier. Start by carefully cutting the pieces for your living room. The frame of the base of the hall will need a couple of two to four axes cut six inches in length. The rear section has a pair of two-to four-axis cut four inches in length.
The wooden cross pieces that you lean back and sit on a needone of two bearings. These pieces should be cut out of five 58 cm long been possible, but may be extended if necessary. Divide the anchor in the same length and four centimeters to add the width of two of the four plates. Repeat the same for the 4-1 with three fields, which are installed on the seat and backrest. The width of the pieces needed to make the entire length of the pieces.
To the back of the room, carefully cut a pair of one of the three pieces. These parts must be structured with theHypotenuse of a triangle of 45 degrees from the position of the backrest. Split a pair of one of the two bodies of four inches behind the connection of the backrest to the seat frame. Set the router to the table at intervals to meet your needs.
The legs of the living room can be made from any material. Four two-four of the board carefully cut to desired length. Sharing is the pair-lounge style you want. The elbow of the arm mustbe done to two inches thinner. Share supports a pair of perpendicular to the planned height. Position the holes for the screws for the connection. Sand all sides to make paint adhere well to wood and the problem of unwanted fragments.
To assemble your living room, with the start of frame two. Put the pieces on both sides of four by means of screws. You can also attach bolts on the legs of the frame. Move the seat and backrest slats for the salonFramework to enable the free movement of goods. Mount the frame to the seat and back and place a large hole at the intersection of the backrest and seat. You can protect your nails that support the pieces to the frame of the seat back. Connect the columns of the back, have thorns.
No comments:
Post a Comment